31022 Zero Air Generator

概要

The Zero Air Generator is a low-cost, handheld source of zero air (air that has been scrubbed of CO2 and water vapor) to be used for zeroing infrared gas analyzers (IRGAs). The 31022 consists of a small pump and a molecular sieve. The pump is powered by 2 AA batteries. A “Test” port located on the 31022 can be used to determine when to replace the molecular sieve.

続きを読む

イメージ

Front Tilt View
Front Tilt View
Front Tilt View
Front View
Front View
Back View
Back Tilt View
Left View
Left Tilt View
Right View
Right Tilt View
Top View
Bottom View

詳細

The 31022 Zero Air Generator provides a source of zero air for zeroing infrared gas analyzers (IRGAs) in both open-path (zero/span shroud required) and closed-path configurations. The zero air generator contains "In," "Out," and "Test" ports, as well as a small battery-powered pump.

During normal operation, air enters the top of the bottle (via the "In" port), which is filled with a molecular sieve. The air flows (0.2 LPM) down the entire length of the bottle, where the molecular sieve removes CO2 and water. The air is pushed into the end of a tube at the bottom of the bottle and then to the "Out" port.

The "Test" port pulls the air from only partway down the bottle, 2 in. above the bottom. Because the unscrubbed air enters the top and flows downward, the molecular sieve is consumed from the top down. Comparing CO2 and water vapor from the "Test" port with the "Out" port indicates when the molecular sieve needs to be replaced.

仕様

Operating Temperature Range -20° to +50°C
Capacity 750 ml (holds approximately 450 g molecular sieve)
Flow Rate 0.2 LPM (typical)
Power 2 AA batteries
Dimensions 13.97 x 9.65 x 27.43 cm (5.5 x 3.8 x 10.8 in.)
Weight 1.13 kg (2.5 lb)

互換性

The 31022 provides a low flow (0.2 LPM) zero air source for zeroing both open-path (zero/span shroud required) and closed-path infrared gas analyzers (IRGAs).


よくある質問

31022に関するよくある質問の数: 4

すべて展開すべて折りたたむ

  1. モレキュラーシーブは、どの国にも出荷できる非危険物です。

  2. モレキュラーシーブは、古い過塩素酸マグネシウムボトルの直接の代替品です。モレキュラーシーブは、古いボトルを使用していたすべてのCampbell Scientifcのアナライザに使用できます。

  3. モレキュラーシーブは、当社のエンジニアリング部門によって、空気サンプルから CO2 と H2O を除去するのに効果的であることが実証されています。変更が行われた理由は 2 つあります。

    1. それは以前の化学物質を使用するよりも安全な代替手段でした。
    2. 化学物質の輸送規制が強化されたため、サプライヤーの数が制限されました。
  4. ドロップイン交換用のボトルには、ペレットと上部の膜が入っています。膜は、ガスがゼオライトを通過できるようにしながらペレットを封じ込めるために必要です。ボトルの設置面積は、古い過塩素酸マグネシウムのボトルと同じです。各ボトルの量はボトルに記載されています。各分析装置に必要なモレキュラーシーブの量は次のとおりです。

    • EC150 には 22 g (ドロップインボトル) が必要です。
    • IRGASON® には 22 g (ドロップインボトル) が必要です。
    • EC155 には 22 g (ドロップインボトル) が必要です。
    • AP200 には 500 g (詰め替え用) が必要です。
    • 27423 には 1000 g (詰め替え用) が必要です。
    • 31022 には 500 g (詰め替え用) が必要です。

記事とプレスリリース

ニュースレター記事


Privacy Policy Update

We've updated our privacy policy.  詳細はこちら

Cookie Consent

Update your cookie preferences.  クッキーの設定を更新する