FAQs Frequently Asked Questions about Our Products and Solutions

Ask a Question Ask a Question

All FAQs (1988 total: showing 361-380)

How can RTMC Run-Time be made to run faster?
Is the one copy of RTMC Run-Time that is included with the purchase of LoggerNet only for use on the same system as LoggerNet, or can it be installed on a different system?
What is the difference between the microSD cards that Campbell Scientific sells and the cards that are commonly used in the consumer electronics at home?
Can the CS11-L activate a small relay?
Can the CS11-L be used to measure amperage from a battery?
Can the CS11-L be used in a three-phase power situation?
How can the CS11-L be used on a data logger other than a CR200(X)?
How is the CS11-L an improvement compared to the retired CS10-L and CS15-L?
Can an ST350 be used in instrumental pile load tests with cast-in-situ (bored) concrete piles?
What needs to be done to measure ST350 Strain Transducers using a Campbell Scientific data logger?
What is the microstrain limit for the ST350?
Is one 4WFBS350 or 4WFBS120 required for each ST350 connected to a data logger or multiplexer?
When should a guy kit be used on a CM106B?
When the GPSReady variable is not 10, does the data logger still synchronize with the PPS signal?
If the “pps” field returned by the GPS() instruction usually displays “990000,” what might be the cause?
If the “gps_ready” output of the GPS() instruction is stuck at or near zero and the data logger clock is not being set, what might be the cause?
How can latitude and longitude data from a GPS16X-HVS receiver be recorded on a data logger and then parsed out?
How can four GPS16X-HVS receivers be connected to the COM ports of a data logger to read all four NMEA strings?
What battery options are available for the 25295?
Does the regulator for the 25295 draw power from the battery during the night?

Previous Next

CAMPBELL SCIENTIFIC JAPAN

country map

会社名	キャンベル・サイエンティフィック・ジャパン株式会社

Website Feedback Website Feedback © 2024 Campbell Scientific Japan