Toggle navigation
Products
Solutions
Support
About
Home
Products
Solutions
Support
About
Quote List
Contact
Regional Websites
Regional Websites
Africa
Australia
Brasil
Canada
Centro Caribe
Deutschland
España
Europe
France
India
Japan
United States
ภาษาไทย
中国
Country Directory
Log In
FAQs
Frequently Asked Questions about Our Products and Solutions
Ask a Question
Ask a Question
Search
All FAQs
(1988 total: showing 801-820)
Is the crosswind correction applied to the raw data of the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH?
Are there any corrections to the raw data (not the average data) obtained by the CSAT3/3A/3AH?
Can the CSAT3/3A/3AH give a time stamp with each measurement value?
What is the direction definition of vertical wind speed for a CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH? For example, does a negative value mean upward or downward?
What should be done if the CSAT3/3A/3AH cannot be found in the Short Cut list of sensors?
Are there any data logger programming changes that must be made to a program when using a long Synchronous Device for Measurement (SDM) cable with a CSAT3?
Can a CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH be used to measure wind flow angle, horizontal angle, and wind speed for the purpose of power curve testing?
If the polymer coating at the ends of the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH transducers starts coming off, is that a problem?
What is the absolute accuracy of the speed of sound measurement in the CSAT3/3A/3AH?
Are there any mounting options for the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH that lend themselves to frequent repositioning?
If the temperature drops below -30°C, is that a problem for a CSAT3A or CSAT3B?
Is the CSAT3/3A/3AH only compatible with Campbell Scientific data loggers?
Is the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH anemometer measurement limited by precipitation?
Can the bubble level on the CSAT3/3A/3H be replaced?
Can the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH be used in low-speed conditions, such as less than 5 cm/s? If so, what are the resolution and accuracy at these low speeds?
What are the mounting options for the CSAT3?
Is the offset relatively constant for a single CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH?
How often does a CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH anemometer need to be recalibrated?
Is there a way to determine the time at which the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH started reporting data with sub-second precision?
How sensitive are the CSAT3A, CSAT3AH, CSAT3B, and CSAT3BH velocity measurements to sea spray in periods of high wind speed?
Previous
Next