I have a environdata sr10 solar radiation sensor that is 0-10hz output but i cant get the pulsecount to read it properly it reads a value when i disconnect and connect but at the next scan (set to 10 sec) it goes to zero. my code is pulsecount (solar-rad,1,2,0,0,1.0,0).
Hi. The pulse count instruction as you have it shown is configuring the pulse channel to look for a high frequency 5 Vdc square wave signal. Are you sure that is what the sensor is producing?
Hi Notso. I did some checking of my sensor and discovered it was faulty. Yes the output should have been a high frequency 5 Vdc square wave. Thanks for your post.