Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Calculating average wind speed and direction

HigherLench Nov 26, 2017 05:51 PM

I have a CR300 datalogger and use an 03002 wind speed and direction sensor. Could I ask how I use WindVector to calculate the average wind speed and direction over the preceeding 10 minutes? I recognise the issue in averaging the direction due its cyclic functionality

JDavis Nov 27, 2017 04:04 PM

All you need to do is use the WindVector instruction in a data table that has a 10 minute data interval. WindVector takes on the interval of the table.

HigherLench Nov 27, 2017 07:46 PM

Many thanks, I'm new to this. I guess the Sample utility gives an instantaneous reading, independent of the data interval?

JDavis Nov 27, 2017 08:30 PM

Yes, a Sample is the last reading within that time interval.

Log in or register to post/reply in the forum.