Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Is it possible to connect a CR300 to a NL240, a RF4xx and a SDI-12 sensor?

BRCBorges May 20, 2018 02:33 AM

Hi,

I have a CR300 next to my office where I have few sensors like tipping bucket and a CS215. I want to put a radio RF422 on it to communicate to a CR1000 far from my office. I also want to use a NL240 with this CR300 to access all collected information from my desktop. Using the Network Planner it seems possible, one device in the RS-232 and the second one using a RS-232 through both control ports (C1 and C2). However, there is no room for a SDI-12 sensor.

Is there any way to connect all communication devices and my SDI-12 sensor or I need to change my datalogger to, at least, a CR300_RF422?

Thank you very much.

Best regards.

Borges

aps May 21, 2018 02:44 PM

If you are going for a new logger, then you probably need a CR310-RF422 as the starting point, leaving all the serial ports and control ports free for sensors.

BRCBorges May 23, 2018 02:25 AM

Thank you!

Best regards

Log in or register to post/reply in the forum.