Hi
I am trying to wiring the data log CR300 to a multiplexer (AM16/32B).
From my understanding, we have to wiring the SW12 V, G, C1 and C2, with common lines going back to the multiplexer 12V, G, CLK, RES.
I have attached a picture of these wiring. To make it work, Campbellsci also indicated to get the terminal input module 4 wire full bridge (Terminal Input Module 4 Wire Full Bridge 350 Ohm 0.02% Ratio Tolerance w/Shunt Terminal Input Module (0 +/- 2ppm/C), which I had ordered.
However, I am still confusing how to connect it. Is there any manual/tutorial explaining how to make those wiring/connections?
I appreciate any help.
Hi Jessica,
I would suggest using ShortCut which is part of the Loggernet software. There you can select the Logger, add the Mux and whatever you are trying to measure with the TIM modules you have purchased. That would provide you with a wiring diagram and a program to get your project started.
Dave
Hi Dave
Sounds good! Thanks for your reply!