I have the drucks setup in a 4-wire configuration using the BrFull() instruction. When I try to set it up with the BrFull6W() instruction the druck reads stage backwards, e.g. move the druck up, and stage goes up. I'm not sure why it's doing this. I've check the wiring and code a hundred times. Ideas?
Problem was resolved by email. Two of the wires required for the six wire configuration were not attached inside the druck. This was verified by testing for resistance across the black and orange wire, which I got 0 ohms, i.e. not connected to anything. I've learned that since GE bought the Druck company and shipped manufacturing to Mexico the quality has dropped off.