Hello,
A few questions regarding using pakbus protocol over a wifi network.
I will have a few CR300 loggers that will have a wifi network connection. They will not be in wifi range of eachother, but in range of an existing wifi mesh network. Four of these will have non-vented pressure transducers and a 5th will have a barometer and other sensors. I'd like to send out water level data compensated for atmospheric pressure.
1) Can I send data via pakbus over this wifi mesh network, or does pakbus only apply to direct radio connections between loggers?
2) If so, would it be more sensible/effecient to populate the single barometer logger with pressure data from the four stations and email that data to the network, or vice-versa, populate each transducer logger with barometer data and email all those.... I think the first - answering my own question...
3) Outside of using loggernet, are there any CRBasic examples to set this up? For example:
A. I'll need to make sure clocks are all synched and correct
B. Looks like there are a few commands for sending data via pakbus.
C. Where in the program flow is it best to execute pakbus commands?
Thank you so much!
zach