Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

EasyFlux "Undeclared Variable d"

duribef Mar 12, 2019 02:43 PM

Hi,

I recently installed an IRGASON with a CR3000. The sensor with an old code give the corrected roughly estimated fluxes, but I want to use the EasyFlux CRBasic program to use the fully corrected fluxes of CO2 and H2O. When i'm trying to Compile and send the code (EasyFlux-DL_CR3OP_v1.2), but this error ocurrs:

Compile Failed!

l

ine 4008: Undeclared variable d.

line 5224: Undeclared variable d.

This variable is related to the "Displacement height" and is alredy declared in the line 657.

Now I don't know how to procced, because i have set the only necessary constants descrived in the instruction manual of EASYFLUX DL CR3000OP.

Thanks.

hmahan Mar 12, 2019 04:53 PM

Hi Diego,

Do you mind sending your program to hmahan@campbellsci.com? I'd like to take a look at it because when I compile the same version program I'm not seeing the compile error. 

Thanks,

Hayden Mahan

Clare Jul 13, 2020 08:46 AM

Hi Diego, 

Did you find the solution to your problem? I am trying to compile it in my CRBasic and I always have this problem of "undefined d" even that it is declared as variable..

Thank you

CSLC

Log in or register to post/reply in the forum.