Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

ProcessTime for WXT520

censamkoh Mar 20, 2019 02:40 AM

I have a CR6 datalogger with only a WXT520 sensor connected.

My program was set to scan every 1 second, when I was getting many skipped scans and records. I fixed this by increasing scan time to 2 seconds.

My program is quite simple so I was surprised to discover that the ProcessTime for each scan was about 1.1 seconds.

Is it normal for the ProcessTime to be this long? At 1200 bauds, does it take a long time to retrieve data from the WXT520?

smile Mar 21, 2019 08:28 AM

Hi

if use SDI-12 protocol, yes.

I had speeded up a little by using the R command instead of M

Smile

Log in or register to post/reply in the forum.