hello,
I am trying to configure a PPP connection on the COM1 of the CR1000 with Maestro M100 3G modem.
connection
Maestro - CR1000
2(TxD) - C2(RxD)
6(RxD) - C1(TxD)
9(GND) - G(Gnd)
With Putty I configure modem with factory settings
Q:0 V:1 S0:000 S2:043 S3:013 S4:010 S5:008
+CR:0 +CRC:0 +CMEE:0 +CBST:0,0,1
+SPEAKER:2 &C:1 &D:2 %C:0
+ICF:3,4 +IFC:2,2
In device Config I have chosen or taped
COM1 set on 115200 for PPP
IP adress 0.0.0.0
Modem dial string AT+CGDCONT=1,"IP","orange.ne";AT*99***1#
Modem dial Response CONNECT
On PPP Network Status I should see IP adress but it remain:
PPP state: dial failed->dialing START
IP:0.0.0.0
gw:0.0.0.0
I need for your assistance and advices in order to establish the connection Modem - CR1000 via COM1.
Best regards
MAINASSAR
hello,
I am trying to configure a PPP connection on the COM1 of the CR1000 with Maestro M100 3G modem.
connection
Maestro - CR1000
2(TxD) - C2(RxD)
6(RxD) - C1(TxD)
9(GND) - G(Gnd)
With Putty I configure modem with factory settings
Q:0 V:1 S0:000 S2:043 S3:013 S4:010 S5:008
+CR:0 +CRC:0 +CMEE:0 +CBST:0,0,1
+SPEAKER:2 &C:1 &D:2 %C:0
+ICF:3,4 +IFC:2,2
In device Config I have chosen or taped
COM1 set on 115200 for PPP
IP adress 0.0.0.0
Modem dial string AT+CGDCONT=1,"IP","orange.ne";AT*99***1#
Modem dial Response CONNECT
On PPP Network Status I should see IP adress but it remain:
PPP state: dial failed->dialing START
IP:0.0.0.0
gw:0.0.0.0
I need for your assistance and advices in order to establish the connection Modem - CR1000 via COM1.
Best regards
MAINASSARA