Hi there,
i have a sensor output with RS232
I need to send the command like "“get-x&y" and the respone should be the result of tilt meter"123.222,123,333" (in degree unit)
https://www.leveldevelopments.com/wp/wp-content/uploads/documents/How2_SOLAR232.pdf
could anyone advise how should i do? how can i connect to CR1000
thank you so much.
See CR1000 manual, section 11.8 Serial I/O (starts on page 244 in my pdf version which is Rev9/09)
Post again when you run into problems?
Or you get lucky and someone that reads this forum and has got this sensor connected and is willing to share his code replies at some point ;-)
Dear Nico,
thank you for your information, i will try to do it.