I am working with a few CR500 datalogger models. I am attempting to reporgram to deploy weather stations in the field. These loggers were used by a different lab a number of years ago. After writing a program using shortcut, I was able to send the program with success. However, when attempting to collect data, I was unablle to overwrite the previous data. These seemed to be because the CR500 is a mixed array of a CR510-PB, CR500-TD, and CR9000X.
I am wondering if there is a way to restore the CR500 to factory settings.
Thank you!
*A mode, goto until parameter 5 and key 98765
this completely reset the logger
Smile