Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

CR1000 OS failed to update

Samurai Japan Mar 18, 2023 02:56 AM

Hi.
I failed to update my CR1000 from OS version 12 to 32.
I can't boot it anymore.
I have tried various communication speeds, but to no avail.
Do I need to use FTDI's USB to RS232C cable?
Thank you in advance for your help.

JDavis Mar 20, 2023 06:58 PM

If the OS update failed part way through, you will need to use the Send OS tab in Device Configuration Utility to do the update process again.

You need a computer with a built in RS232 port, or a USB to RS232 adapter that uses a FTDI chip. Prolific RS232 chips have been observed to not be reliable enough to complete the process.

Samurai Japan Mar 22, 2023 12:15 AM

This post is under review.

Log in or register to post/reply in the forum.