Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

How to update the CR1000X card in DEV config


benomar Jun 22, 2023 07:33 AM

Hello,

I hope you are doing well. I have a small issue with my CR1000X card. When I configure it with a Sierra LX60 modem, it works correctly.

However, if I remove the card's limitation, I need to change the port and go back to the original port. I would like to know if there is a way to update the card and have it retrieve the IP address without going through another port and returning to the initial port. How can I make the card self-update and capture the IP address in the DRV config?

Best regards.

Log in or register to post/reply in the forum.