Hello everyone,
I hope you're doing well. I'm reaching out to you seeking help with a small issue I'm facing. I recently acquired an RM Young 81000 ultrasonic anemometer and a CR1000x datalogger, but I haven't been able to display the measurements so far. As I'm a beginner with Campbell, I was wondering if any of you could provide me with a code or guide to visualize the measurements in an analog format.
I appreciate any assistance or advice you can offer. Thank you in advance for your support.
https://s.campbellsci.com/documents/ca/manuals/81000_man.pdf
take a look at the manual.
What connection do you want to make?
the simplest is to use the analog channels.
With the analog outputs you need some free channels on the logger and a cable with several conductors, in RS232 a serial port is sufficient (IE control ports C1 and C2 ) but the program could be more complicated.
Smile