Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Any way to do factory setting in CR3000?


almahdory Aug 23, 2023 08:32 AM

Any way to do factory setting in CR3000?


JDavis Aug 23, 2023 04:32 PM

Options:

Connect with Device Configuration Utility. Use Factory Defaults button at bottom of screen. Click Apply.  - This option will default settings, but not erase files.

Set FullMemReset in the Status table of the data logger to 98765. - This method will put settings on defaults and erase files and data on the data logger.

Use Send OS tab in Device Configuration Utility to send an operating system file to the datalogger. - This method will completely put the data logger in factory default state. All settings will be on default and all memory locations are reset.


victoriafeest May 9, 2024 10:14 AM

The datalogger can be configured by sending an operating system file through the Device Configuration Utility's Send OS tab. - Using this procedure will reset the data logger to its factory settings. Everything is reset to factory default, including the memory locations. basketball stars

Log in or register to post/reply in the forum.