Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

8 thermistors wired to CR1000


Maratapat Feb 25, 2013 08:58 AM

Hi all,

I'm very new to playing with dataloggers, so any help would be very much appreciated!
I am trying to keep my game as simple as possible. The plan is to wire 8 thermistors to a CR1000, with half-bridge configuration(s). Any idea how I can wire everything together? I got the system logging with one thermistor, but I cannot see how I can connect the other thermistors to the circuit. I'm trying to avoid using multiplexers.
Thank you!


JDavis Dec 7, 2020 09:26 PM

To see an example, add 8 of the 107 temperature probe to a CR1000 in ShortCut. It will use the Therm107 instruction, but is half bridge wiring.

Another example would be adding 8 of Generic>Half Bridge in ShortCut to the datalogger.


sabrinacollinsss Nov 29, 2023 06:41 PM

This post is under review.

Log in or register to post/reply in the forum.