Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

PulsePort on CR6 using U ports


Monte Feb 13, 2024 11:11 AM

Hi

Which voltage is used with PulsPort on a CR6 using U-ports?
Is it 5.0 or 3.3 volts?

Does PulsePort start with high or low level?
Or depens it on which level the port is when the instruction is executed?
Will say: When the port is previousely set to a high state "PortSet(U4,1)". Then it will go from high to low to high, and then a second time to low to high?
When previousely set to low "PortSet(U4,0)". Then it will go from low to high to low, and then again to high to low?


juliacarter Feb 21, 2024 10:27 AM

This post is under review.


Nanisa121 Mar 21, 2024 03:51 AM

This post is under review.

Log in or register to post/reply in the forum.