Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Using PPS signal without GPS to sync logger time


tronix Apr 10, 2024 10:45 PM

I have two CR1000x loggers that I would like to keep synchronised by using a PPS signal from a GPS module which is not attached to any of the two loggers. Is there a way that I can use the logger time or time from an NTP server as the source time  in the GPS() command instead of the GPS time from the NMEA string?

If not, is there any other way to use the PPS signal to synchronise logger time without a GPS?


JDavis Apr 12, 2024 06:10 PM

In your case, use the NetworkTimeProtocol() instruction to synch to a NTP server.


tommison1 Apr 19, 2024 02:57 AM

This post is under review.

Log in or register to post/reply in the forum.