Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Is it possible to use the multiple SDI12-recorder calls in fast and slow scan?


SensAlpin May 28, 2024 09:07 AM

Hello,

i have come across a basic question regarding SDI12 recorders and various scans.
Several SDI sensors are conntected on a CR1000x logger, some on the same channel, and would like to use SDI12-Recorder. Until now, this was done in one scan and the sensors had different addresses and worked fine. Now a new sensor sometimes takes a very long time to respond. Therefore, the idea was to outsource this to a separate SlowScan. This seems to work in itself, but the SDI12 recorder returns a call from the fast scan after a slowscan NAN.
On a CR800 with a similar setup, only NAN is returned in the fast scan.

So is it possible to run several SDI12 recorder calls in different scans? As far as I understand, both the measurement triggering and the responses from the sensor are provided with the address.

Thanks for any effort to answer

Log in or register to post/reply in the forum.