Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Sending datatable from CR310 to a CR1000X


Antoine.cote Jul 23, 2024 01:54 PM

Hello,

I need help to understand if it's possible to done what i'm looking for.

Configuration:

On a buoy, we have a CR310 that if connect via RS-232 to a modem RF500M and send via a radio. We have three buoys.  To preserve the battery, the site is remotely accessible for a short periode of time ( 4 time of 15min during the days)

On a remote site, we have a radio and a base modem RF500M that is connected with RS-232 to a NL-201.  On the same remote site, we have a CR1000X.  Both the CR1000X and the NL-201 are connected to a network switch.

Presently if i want to collect the data on each CR310, i need to connect on it and collect data manually.  I try to collect data with a ftp server, but we have network restriction that make it impossible.

Question:

Is it possible with the CR1000X to automatically collect data form the three CR310 to store it in the CR1000X?

I'm looking at the getdatarecord, getfile, getrecord, getvariables, sendgetvariables, but i'm a bit lost in all the possibility.

I have 5 variable to collect: date, time, record#, data 1, data 2 on each CR310. 

Thanks

Log in or register to post/reply in the forum.