Hello,
We have a new (unused) CCFC camera, purchased in December 2023, on shelf since. We applied the required (red to 12V) (black and clear to G) and powered the camera on. It starts off with 2 short flashes on the back button/Status LED. The status LED then stays on, and does not turn off, We have waited several iterations where we lets it go over 2 minutes, and then cycled power again. The result has been the same for over 4 iterations. We do not see a Wifi signal, which we were going to use for initial setup. The Status LED staying on and solid, and not seeing any wifi signal appears to indicate it is booting up, and then getting stuck into the Boot sequence. The serial number for the camera is 2537. The red wire is connected to the CR1000X 12V port. When the CCFC camera cable is not connected to the camera, the voltage on the 12V port is about 12.4 VDC. It drops to about 12.0 VDC, when connected.
Are there any steps to help resolve this issue?
Found this article, that relates to the above issue. Would the above state be considered non-functinoal?
https://s.campbellsci.com/downloads_ltbb/os/CCFC%20Outdoor%20Observation%20and%20Surveillance%20Field%20Camera%20Recovery%20and%20Update%20Manual.pdf