利用できるサービス | |
---|---|
修理 | 非対応 |
キャリブレーション | 対応 |
フリーサポート | 非対応 |
The CR10 was a predecessor of the CR10X. The CR10X was eventually replaced with the CR1000. The CR10 consisted of a CR10M Measurement and Control Module and a CR10WP Wiring Panel.
続きを読むThe CR10 had 12 single-ended (six differential) analog input channels, three switched excitation outputs, eight input/output control ports, two pulse counting channels, and a serial I/O port. It provided sensor measurement, timekeeping, data reduction, data/program storage and control functions. Up to 29,908 data points were stored in it's internal memory.
CR10s manufactured after 1 December 1993 (SN>19273) contained an internal jumper that supported use of 2 or 4 kbytes program memory (appropriate PROM also required).
-NOTE- | Note: Additional specifications are listed in the CR10 Specifications Sheet. |
Analog Input Channels | 12 single-ended (six differential) |
Switched Excitation Outputs | 3 |
Input/Output Control Ports | 8 |
Pulse Count Channels | 2 |
Serial I/O Port | 1 |
Memory | Stores up to 29,908 data points in internal memory. |
A typical field-based CR10 system consisted of:
CR10 peripherals such as the CR10KD and CR10TCR, as well as sensors and data retrieval peripherals, were added to complete the system.
CR10に関するよくある質問の数: 1
実用的な最大値は、データロガーの 2 つのCターミナルごとに 1 つのマルチプレクサを接続することです。Cターミナルをマルチプレクサ間で共有して、接続するマルチプレクサの数を増やすことができます。ただし、ターミナルを共有するには、より複雑な配線とプログラミングが必要です。2 つのCターミナルごとに 1 つ以上のマルチプレクサを接続したいユーザーは、Campbell Scientific の営業またはサポート エンジニアに問い合わせて支援を受けることをお勧めします。
We've updated our privacy policy. 詳細はこちら
Update your cookie preferences. クッキーの設定を更新する