CS630-L 3-Rod 15 cm TDR Probe with Standard Cable
High-Conductivity Soils
Up to 15 m cable length
気象 applications 水 applications エネルギー applications ガスフラックスと乱流 applications インフラ applications 土壌 applications

概要

The CS630 is used in TDR100- and TDR200-based systems. This probe consists of a Santoprene head, three pointed rods, and a standard RG58 cable. The length of each rod is 15 centimeters, allowing the probe to be used in high electrical conductivity soils (maximum soil bulk electrical conductivity of 3.5 deciSiemens/meter). The RG58 cable is suitable for lengths up to 15 meters (50 ft) as measured from the tips of the probe's rods to the reflectometer. A similar probe, the CS635, is recommended for applications requiring longer cable lengths. The CS630 and CS635 differ only in their cables.

続きを読む

イメージ

詳細

The CS630 acts as a wave guide. Impedance along the rods varies with the dielectric permittivity of the surrounding soil. Because the dielectric permittivity of soil primarily depends on the amount of water present, soil volumetric water content can be inferred from the reflected measurements. Soil bulk electrical conductivity is determined from the attenuation of the applied pulse.

仕様

Maximum Soil Bulk Electrical Conductivity 3.5 dS/m
Rod Diameter 0.32 cm (0.125 in.)
Rod Length 15 cm (5.9 in.)
Santoprene Head Dimensions 5.75 x 4.0 x 1.25 cm (2.25 x 1.57 x 0.49 in.)

互換性

注意： 以下は代表的な互換性情報を示しています。互換性のある製品や互換性のない製品をすべて網羅したリストではありません。

Measurement and Control

製品 互換性 注意
SDMX50 (リタイア)
SDMX50LP (リタイア)
SDMX50SP (リタイア)
TDR100 (リタイア)
TDR200

よくある質問

CS630-Lに関するよくある質問の数： 1

  1. How far can an SDMX50-series or SDM8X50 multiplexer be separated from a TDR100 or TDR200?

    In applications where TDR probes are used to measure soil water content, the maximum distance from the TDR probe back to the TDR100/TDR200 (even through one or more multiplexers) cannot exceed 15 m (50 ft) when using RG58 coaxial cable; the CS605-L, CS630-L, and CS640-L TDR probes have an RG58 cable. When using low-loss coaxial cable, the distance cannot exceed ≈25 m (80 ft); the CS610-L, CS635-L, and CS645-L TDR probes have a low-loss coaxial cable.

    In slope stability and rock mass deformation applications, the maximum coaxial cable length should not exceed ≈1 mile (5,280 ft). The maximum combined length of all SDM cables in the system should not exceed ≈76 m (250 ft).

よくある質問一覧はこちら

以下に記載

下記製品のその他アクセサリです：

Privacy Policy Update

We've updated our privacy policy.  詳細はこちら

Cookie Consent

Update your cookie preferences.  クッキーの設定を更新する