Hardware
- Two additional differential analog input channels (four single-ended)
- Range on all analog input channels increased to ±5 V
- 50/60 Hz rejection uses full cycle integration
- Pulse inputs have 24-bit counters; maximum input frequencies do not require special configuration
- Switched 12 V does not require use of control port
- Custom ASIC chip gives the eight control ports the capability for:
- Pulse counting: all eight ports support direct input of high frequency signals or switch closures, low level AC possible with LLAC4
- Pairs of ports can be configured as COM ports with the capability for serial communications:
- 300 to 115200 baud
- Smart sensor input, no SDM-SIO4 needed
- Short distance wired network (up to 50 feet)
- CR1000-to-CR1000 communications
- RS-232 communication interface port (not isolated) in addition to CS I/O
- Parallel interface port for CompactFlash Storage Module
- Standard memory equivalent to CR10X-2M, 4 M optional
- Four times the processing speed
- Lower quiescent current
- Battery-backed clock is accurate to 3 minutes per year
Operating System
- CRBasic programming language
- PakBus® communication protocol
- Table Data Storage
