Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.
Question/Topic Posted By Replies
StrainCalc help: strain is not being calculated correctly kmsei-engr 0
dual connection for redundancy (ethernet port + ls300) for cr1000 maurixio 0
Connecting a CS650 in a CR300 Datalogger Moletto-Lobos 2
sdm-sio1a module problem uta 6
NL116 and NL240 LGS 1
Does CRBasic subroutines support variable parameters (aka. optional parameters)? Minh T. 2
Unexpected Behavior with pointers (Where to report bugs?) Carli 0
Hex to Short (16-bit signed) kevnoto 1
Pulling to ground | Pulling to float | Iridium9602 Sleep Line ZMS 1
Data Encryption cunningham 7
CR5000 freezing up Jdavid 10
sdi12 timing problem, 1Hz, four WindSonic4 on one CR3000 Phil_AT 4
New Modem BGS5 - Problem with PPP gbventura 1
Connection with CR6 with Public IP address wireless in device configuration utility kokihualpa 3
CR1000 Rebooting ERROR SOLER 3
PC400 v1.5 to v4.3 mortenx 3
date/time settings PVAL 1
Animated gif Makada 6
OBS300 and suspended solids totals kokihualpa 3
Temperature Sensor 3 wires Rafael 5
Modification of a registred value Jamal 1
Read IR120 wit a Arduino Board quiqueapolo 1
SC105 configuration - cannot connect burright 0
Conditional datatable Makada 12
Connecting a CS650 in a CR300 Datalogger Moletto-Lobos 1
Connect two IR120 in the same Vx1 quiqueapolo 1
Air temp estimation Jamal 1
Cellular modem callback with confirmation of data collection? burright 1
SPLIT 2.1 wx2day 1
how to .. cr1000 data to online public ? mortenx 6