RETIRED ›
This product is no longer available.
253-L Soil Matric Potential Block for Multiplexer Use
利用できるサービス

概要

The 253, manufactured by Watermark, is a solid-state, electrical-resistance sensing device with a granular matrix that estimates soil water potential from 0 to -200 kPa (typically, wetter or irrigated soils). It connects to your data logger via an AM16/32-series multiplexer and is intended for applications where you will be monitoring a larger number of sensors. 

続きを読む

利点と特徴

  • Survives freeze-thaw cycles
  • Compatible with AM16/32-series multiplexers, allowing measurement of multiple sensors
  • Multiplexer connection prevents electrolysis from prematurely destroying the probe
  • Rugged, long-lasting sensor
  • Buffers salts in soil
  • Compatible with most Campbell Scientific data loggers

イメージ

詳細

When the amount of water in the soil surrounding the sensor changes, a difference in water potential between the soil and the sensor material is established. This gradient in potential causes a water flux between the two materials. For example, an irrigation or precipitation event results in movement of soil water into the 253 until equilibrium in water potential between the sensor and the soil occurs. An increase in the amount of water in the sensor reduces the electrical resistance between the sensor electrodes.

The data logger measures the resistance between electrodes, and then converts the resistance measurement to soil water potential by using calibration values supplied with the sensor.

The 253 consists of two concentric electrodes embedded in a reference matrix material. The matrix material is surrounded by a synthetic membrane for protection against deterioration. An internal gypsum tablet buffers against the salinity levels found in irrigated soils. The cable jacket is made of Santoprene rubber, which is resistant to temperature extremes, water, and UV degradation. 

The 253's construction can allow the sensor (in some circumstances) to be left in the soil all year, eliminating the need to remove the sensor during fallow periods.

The 253 connects to a data logger via an AM16/32-series multiplexer. Because the multiplexer contacts close only during measurement, electrical currents leading to premature degradation of the 253 are eliminated.

仕様

Measurement Range 0 to -200 kPa
Diameter 1.91 cm (0.75 in.)
Length 8.26 cm (3.25 in.)
Weight 360 g (0.8 lb)

互換性

注意: 以下は代表的な互換性情報を示しています。互換性のある製品や互換性のない製品をすべて網羅したリストではありません。

Data Loggers

製品 互換性 注意
CR1000 (リタイア)
CR1000X (リタイア)
CR300 (リタイア)
CR3000 (リタイア)
CR310
CR350
CR6
CR800 (リタイア)
CR850 (リタイア)

Measurement and Control

製品 互換性 注意
AM16/32 (リタイア)
AM16/32A (リタイア)
AM16/32B
AM416 (リタイア)

Privacy Policy Update

We've updated our privacy policy.  詳細はこちら

Cookie Consent

Update your cookie preferences.  クッキーの設定を更新する