034A-L Met One Wind Set

Wind Speed and Wind Direction Sensors / 034A-L

RETIRED ›
This product is no longer available and has been replaced by: 034B-L.

Services Available
Calibration	No

Images
Similar Products
Compatibility
Documents
FAQs

Overview

The 034A Windset (pn 10576) combined a 3-cup anemometer and vane into a single integrated package. It was constructed out of lightweight aluminum and designed for continuous long-term operation.

Images

Similar Products

014A-L 3-Cup Anemometer

27106T-L Vertical Propeller Anemometer

03101-L Wind Sentry Anemometer

03301-L Wind Sentry Vane

024A-L Wind Direction Sensor

P2546A-L Three-Cup Anemometer with MEASNET Calibration

03002-L Wind Sentry Set

034B-L Wind Set

05103-L Wind Monitor

05305-L RM Young Wind Monitor AQ

WINDSONIC1-L 2-D Sonic Wind Sensor with RS-232 Output

WINDSONIC4-L 2-D Sonic Wind Sensor with SDI-12 Output

CSAT3A 3-D Sonic Anemometer, Head Only

020C-L Wind Direction Sensor

Compatibility

Note: The following shows notable compatibility information. It is not a comprehensive list of all compatible or incompatible products.

Data Loggers

Product	Compatible	Note
21X (retired)
CR10 (retired)
CR1000 (retired)
CR10X (retired)
CR200X (retired)
CR206X (retired)
CR211X (retired)
CR216X (retired)
CR23X (retired)
CR295X (retired)
CR3000 (retired)
CR500 (retired)
CR5000 (retired)
CR510 (retired)
CR800 (retired)
CR850 (retired)
CR9000 (retired)
CR9000X (retired)

Additional Compatibility Information

Mounting

The 034A can be attached to a CM202, CM204, or CM206 crossarm via a 17953 NU-RAIL fitting or a CM220 Right Angle Mounting Bracket. Alternatively, the 034A can be attached to the top of our stainless-steel tripods via the CM216 Sensor Mounting Kit. The CM216 extends 4 in. above the mast of a stainless-steel CM110, CM115, or CM120 tripod.

Data Logger Considerations

The 034A's anemometer uses one pulse count channel on the data logger. Its wind vane requires one single-ended channel and access to an excitation channel (the excitation channel can be shared with other high impedance sensors).

Programming

The 034A's anemometer is measured by the PulseCount Instruction in CRBasic, and by Instruction 3 (Pulse Count) in Edlog. The wind vane is measured by the BrHalf Instruction in CRBasic and by Instruction 4 (Excite-Delay-SE) in Edlog. The measurements are typically processed for output with the Wind Vector instruction (not present in the CR500 or CR9000).