利用できるサービス | |
---|---|
修理 | 非対応 |
キャリブレーション | 非対応 |
フリーサポート | 非対応 |
The 105T Type T thermocouple consisted of 24-gage, shielded, copper wire and constantan wire. The copper wire and constantan wire were joined at a measurement junction that was electrically isolated from the soil (or other media). Electrical isolation avoided measurement errors due to differences in ground potential.
注意: 以下は代表的な互換性情報を示しています。互換性のある製品や互換性のない製品をすべて網羅したリストではありません。
製品 | 互換性 | 注意 |
---|---|---|
21X (リタイア) | ||
CR10 (リタイア) | ||
CR1000 (リタイア) | ||
CR10X (リタイア) | ||
CR200 (リタイア) | ||
CR205 (リタイア) | ||
CR206 (リタイア) | ||
CR210 (リタイア) | ||
CR211 (リタイア) | ||
CR215 (リタイア) | ||
CR216 (リタイア) | ||
CR23X (リタイア) | ||
CR295 (リタイア) | ||
CR3000 (リタイア) | ||
CR500 (リタイア) | ||
CR5000 (リタイア) | ||
CR510 (リタイア) | ||
CR800 (リタイア) | ||
CR850 (リタイア) | ||
CR9000 (リタイア) | ||
CR9000X (リタイア) |
The 105T is measured by the TCDiff instruction in CRBasic and by Instruction 14 (Differential Thermocouple) in Edlog. One differential channel per probe is required; a thermocouple reference junction at the data logger is also required. If large numbers of 105Ts are to be measured, the AM25T Thermocouple Multiplexer is recommended. The CR200-series, CR500, and CR510 dataloggers do not have thermocouple measurement instructions and are therefore not compatible with the 105T.
105T-Lに関するよくある質問の数: 2
The information included on a calibration sheet differs with each sensor. For some sensors, the sheet contains coefficients necessary to program a data logger. For other sensors, the calibration sheet is a pass/fail report.
This depends on the information contained in the calibration sheet:
We've updated our privacy policy. 詳細はこちら
Update your cookie preferences. クッキーの設定を更新する