This product is no longer available and has been replaced by: WINDSONIC4-L.
| 利用できるサービス |
|---|
概要
The WindSonic was a two dimensional ultrasonic anemometer that output an SDI-12 signal. Our WindSonics are an alternative to traditional mechanical cup and vane or propeller and vane anemometers. They do not have moving parts, which minimizes routine maintenance.
WindSonics are manufactured by Gill Instruments Ltd.
イメージ
仕様
| Temperature Range | -35° to +70°C |
| Operating Humidity | 0% to 100% RH |
| Power Requirements | 9 to 30 Vdc, 40 mA (continuous) |
| Outputs Parameters | Polar (direction and speed) or orthogonal (L.C. and L.C. wind) |
| Diameter | 14.2 cm (5.6 in.) |
| Height | 16.0 cm (6.3 in.) |
| Weight | 0.5 kg (1.1 lb) |
互換性
注意： 以下は代表的な互換性情報を示しています。互換性のある製品や互換性のない製品をすべて網羅したリストではありません。
Data Loggers
| 製品 | 互換性 | 注意 |
|---|---|---|
| 21X (リタイア) | ||
| CR10 (リタイア) | Requires a special PROM. | |
| CR1000 (リタイア) | ||
| CR10X (リタイア) | ||
| CR200 (リタイア) | ||
| CR205 (リタイア) | ||
| CR206 (リタイア) | ||
| CR210 (リタイア) | ||
| CR211 (リタイア) | ||
| CR215 (リタイア) | ||
| CR216 (リタイア) | ||
| CR23X (リタイア) | ||
| CR295 (リタイア) | ||
| CR3000 (リタイア) | ||
| CR500 (リタイア) | ||
| CR5000 (リタイア) | ||
| CR510 (リタイア) | ||
| CR800 (リタイア) | ||
| CR850 (リタイア) | ||
| CR9000 (リタイア) | ||
| CR9000X (リタイア) |
互換性に関する追加情報
The WindSonic is connected to one control port, +12 Vdc, and ground. The SDI-12 instruction is used to collect data from the WindSonic; up to ten WindSonics (each with a unique address) can be connected to one data logger control port.
よくある質問
WINDSONIC-Lに関するよくある質問の数： 2
-
After installing the mounting pipe, place the orientation ring, followed by the wind sensor, on the mounting pipe. Orient the junction box to the south, and tighten the band clamps on the orientation ring and mounting post. Final sensor orientation is done after the data logger has been programmed to measure wind direction as described in Appendix A of the instruction manual.
-
Yes, but only with the appropriate CRBasic program. Short Cut does not support that type of programming. The custom program would have to be written by someone at Campbell Scientific, and the client would be charged for the time to write and test the code.
ケーススタディ
Background In 2022, ECR Medio Ambiente assumed the responsibility of overseeing the structural monitoring installation at......続きを読む
Privacy Policy Update
We've updated our privacy policy. 詳細はこちら
Cookie Consent
Update your cookie preferences. クッキーの設定を更新する